Internet-Draft Anti-Replay Notification in IKEv2 October 2024
Pan, et al. Expires 24 April 2025 [Page]
Workgroup:
IPSECME Working Group
Internet-Draft:
draft-pan-ipsecme-anti-replay-notification-01
Published:
Intended Status:
Standards Track
Expires:
Authors:
W. Pan
Huawei
Q. He
Huawei
P. Wouters
Aiven

IKEv2 Support for Anti-Replay Status Notification

Abstract

Although RFC 4302 and RFC 4303 don't prohibit using Extended Sequence Number (ESN) when the anti-replay function is not enabled, many IPsec implementations require ESN to be used only with anti-replay. Therefore, failing to negotiate the use of ESN when the anti-replay is disabled will cause the sequence numbers to exhaust rapidly in high-traffic-volume scenarios, leading to the frequent rekey of Child SAs.

This document defines the REPLAY_PROT_AND_ESN_STATUS Notify Message Status Type Payload in the Internet Key Exchange Protocol Version 2 (IKEv2) to inform the peer of its replay protection status and capability of using ESN without anti-replay when creating the Child SAs, to address the above problem.

About This Document

This note is to be removed before publishing as an RFC.

Status information for this document may be found at https://datatracker.ietf.org/doc/draft-pan-ipsecme-anti-replay-notification/.

Discussion of this document takes place on the ipsec Working Group mailing list (mailto:ipsec@ietf.org), which is archived at https://mailarchive.ietf.org/arch/browse/ipsec/. Subscribe at https://www.ietf.org/mailman/listinfo/ipsec/.

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."

This Internet-Draft will expire on 24 April 2025.

Table of Contents

1. Introduction

IPsec Authentication Header (AH) [RFC4302] and Encapsulating Security Payload (ESP) [RFC4303] are used to provide security for IP communications. Both AH and ESP support the anti-replay function to prevent an attacker from resending the packets received by the IPsec peer before. Each IPsec packet is sent with a unique sequence number, which the IPsec receiver checks to see whether the sequence number is duplicated.

RFC 4302 and RFC 4303 specify the details of sequence number generation and verification. When anti-replay is enabled on the receiver, the sender must monitor the sequence number counter and increment the counter with every message sent. The sender must ensure that the counter does not cycle, and trigger the creation and use of a new Child SA before the counter is about to cycle. When anti-replay is disabled on the receiver, the sender does not need to monitor or reset the counter. The sender only increments the counter and rolls it over back to zero when it reaches the maximum value.

It is specified in both RFC 4302 and RFC 4303 that, during SA establishment, IPsec implementation should notify the peer if it will not provide anti-replay protection, to avoid having the peer do unnecessary sequence number monitoring and SA setup. However, currently, IKEv2 [RFC7296] does not have the notification of anti-replay status when negotiating the creation of a Child SA. As a result, IPsec implementations must always assume that the peer has anti-replay enabled. Even though anti-replay is disabled on both ends, they still have to monitor the sequence numbers. And this will lead to an unexpected problematic scenario as described in Section 1.1.

1.1. Problem Statement

When anti-replay is enabled on the peer, the IPsec implementation needs to monitor the sequence number of outbound packets, and trigger a rekey to generate and use a new Child SA when the sequence number counter is about to cycle. In high-performance scenarios, high-speed traffic causes the 32-bit sequence number to be consumed rapidly, resulting in frequent rekeying of Child SAs. For this reason, IPsec defines the Extended Sequence Number (ESN) function, extending the available space for sequence numbers from 32 to 64 bits.

Although ESN is good for avoiding the sequence number running out in a short period, there is a prerequisite for using ESN - RFC 4302 and RFC 4303 both state that ESN should be used in conjunction with the anti-replay function. The high-order 32 bits of the sequence number are not transmitted in the wire and should be determined by the receiver. RFC 4302 and RFC 4303 describe a window scheme for both detecting replayed packets and determining the high-order bits. And many IPsec implementations require the ESN to be used only with anti-replay.

In the high-performance scenario, operators may turn off anti-replay for QoS, performance, and other reasons. For example, the high-level QoS packets arriving first may cause a large number of low-level QoS packets to be dropped if the disordered packets exceed the anti-replay window size. However, for the reasons mentioned above, disabling anti-replay corresponds to implicitly disabling ESNs, eventually resulting in IPsec peers failing to successfully negotiate the use of ESNs. The end result is that neither IPsec peer enables anti-replay, but neither can use ESN, forcing the Child SAs to rekey frequently due to the rapid exhaustion of the 32-bit sequence number.

1.2. Possible Solutions

The solution to the problem (Section 1.1) can be approached in two ways.

One option is to support the continued use of the ESN when anti-replay is disabled. Because IPsec packets currently carry only the low-order 32 bits of the sequence number, the ESN has a need for the receiver to manage the anti-replay window in order to determine the correct value for the high-order 32 bits. To use ESN when anti-replay is disabled, the IPsec implementations need to create and maintain a separate window for ESN as well.

The other option is to add a notification of anti-replay status in IKEv2. Section 3.4.3 of both RFC 4302 and RFC 4303 specify that the IPsec receiver should notify the sender during SA establishment that the receiver will not provide anti-replay protection. Adding the anti-replay status notification in IKEv2 can fulfill this requirement. When anti-replay is disabled on both peers, neither peer needs to monitor the sequence number counter, thus avoiding frequent rekey of Child SAs.

2. Requirements Language

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here.

3. Notifying the Anti-replay and ESN Status

When creating a Child SA, the REPLAY_PROT_AND_ESN_STATUS notification payload can be used by the initiator and the responder to inform each other of their own replay protections status (enabled or disabled) regarding this SA and the support of using ESN without anti-replay.

The initiator includes the REPLAY_PROT_AND_ESN_STATUS notification payload in the IKE_AUTH exchange request for creating the initial Child SA or the CREATE_CHILD_SA exchange request for creating the subsequent Child SAs.

A responder that does not support the anti-replay and ESN status notification processes the request as normal, and does not include the new Notify in the response. As per regular IKEv2 processing, a responder that does not recognize this new Notify, MUST ignore it. As required in RFC 4302 and RFC 4303, this responder should assume the anti-replay is enabled in the initiator. The absence of the Notify in the response indicates to the initiator that the responder doesn't support the anti-replay and ESN status notification. The initiator continues the IKEv2 negotiation as usual, and also assumes the anti-replay is enabled in the responder.

A responder that supports the anti-replay and ESN status notification can understand whether the initiator provides the anti-replay protection for this Child SA and/or supports using ESN without anti-replay. The responder will include the REPLAY_PROT_AND_ESN_STATUS notification payload in the response to inform its anti-replay and ESN status about this Child SA.

The IKE_AUTH message exchange in this case is shown below:

Initiator                         Responder
-------------------------------------------------------------------
HDR, SK {IDi, [CERT,] [CERTREQ,]
    [IDr,] AUTH, SAi2,
    TSi, TSr,
    N(REPLAY_PROT_AND_ESN_STATUS)}  -->
                             <--  HDR, SK {IDr, [CERT,] AUTH,
                                      SAr2, TSi, TSr,
                                      N(REPLAY_PROT_AND_ESN_STATUS)}

The CREATE_CHILD_SA message exchange in this case is shown below:

Initiator                         Responder
-------------------------------------------------------------------
HDR, SK {SA, Ni, [KEi,]
    TSi, TSr,
    N(REPLAY_PROT_AND_ESN_STATUS)}  -->
                             <--  HDR, SK {SA, Nr, [KEr,]
                                      TSi, TSr,
                                      N(REPLAY_PROT_AND_ESN_STATUS)}

When the Child SA is successfully established with the REPLAY_PROT_AND_ESN_STATUS notification payloads mutually exchanged, the initiator and responder understand each other's anti-replay and ESN status.

The IPsec implementation can choose not to monitor the sequence number counter of outbound packets if the peer's anti-replay is disabled, and therefore does not need to create and use a new Child SA before the counter is about to cycle.

Knowing the anti-replay and ESN status of each peer can help them in the negotiation of using ESN. If both peers enable the anti-replay, the ESN negotiation is performed as usual. If both peers support using ESN without anti-replay, they can propose and accept to use ESN regardless of the anti-replay status. Suppose one peer disables anti-replay and supports using ESN without anti-replay, and the other peer enables anti-replay and doesn't support using ESN without anti-replay. In that case, both peers support to use ESN and ESN can also be successfully negotiated. If one peer disables anti-replay and doesn't support using ESN without anti-replay, it means that this peer won't propose or accept to use ESN, then the ESN won't be successfully negotiated.

4. REPLAY_PROT_AND_ESN_STATUS Notify Payload Format

The REPLAY_PROT_AND_ESN_STATUS Notify Message type notification is used by the initiator and responder to indicate their own anti-replay status to each other when creating the Child SAs.

                     1                   2                   3
 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+---------------+-+-------------+-------------------------------+
| Next Payload  |C|  RESERVED   |         Payload Length        |
+---------------+-+-------------+-------------------------------+
|Protocol ID(=0)| SPI Size (=0) |      Notify Message Type      |
+---------------+---------------+-------------------------------+
|  REPLAY_PROT  |  ESN_WITH_RP  |            Reserved           |
+---------------+---------------+-------------------------------+

The Critical bit MUST be 0. A non-zero value MUST be ignored.

5. IANA Considerations

This document defines a new Notify Message Type in the "IKEv2 Notify Message Types - Status Types" registry. IANA is requested to assign the codepoint in this registry.

NOTIFY messages: status types            Value
----------------------------------------------------------
REPLAY_PROT_AND_ESN_STATUS               TBD1

6. Security Considerations

TBD

7. Acknowledgments

TBD

8. References

8.1. Normative References

[RFC2119]
Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, , <https://www.rfc-editor.org/rfc/rfc2119>.
[RFC7296]
Kaufman, C., Hoffman, P., Nir, Y., Eronen, P., and T. Kivinen, "Internet Key Exchange Protocol Version 2 (IKEv2)", STD 79, RFC 7296, DOI 10.17487/RFC7296, , <https://www.rfc-editor.org/rfc/rfc7296>.
[RFC8174]
Leiba, B., "Ambiguity of Uppercase vs Lowercase in RFC 2119 Key Words", BCP 14, RFC 8174, DOI 10.17487/RFC8174, , <https://www.rfc-editor.org/rfc/rfc8174>.

8.2. Informative References

[RFC4302]
Kent, S., "IP Authentication Header", RFC 4302, DOI 10.17487/RFC4302, , <https://www.rfc-editor.org/rfc/rfc4302>.
[RFC4303]
Kent, S., "IP Encapsulating Security Payload (ESP)", RFC 4303, DOI 10.17487/RFC4303, , <https://www.rfc-editor.org/rfc/rfc4303>.

Authors' Addresses

Wei Pan
Huawei Technologies
Qi He
Huawei Technologies
Paul Wouters
Aiven